Fully Hammered Brass Kitchen Sink Undermount

Most undermount sinks are hammered where you can see them — the interior walls, the basin floor, the surfaces that face upward into the light. The exterior is an afterthought, hidden behind the cabinet frame and never seen again after installation. This sink does not make that distinction. The hammering covers every face: the interior walls, the basin floor, and the full outer walls of the basin below the counter. It is not a detail that anyone will notice once the sink is installed — and that is exactly the point. It is there because it should be there, because a handmade object deserves to be finished completely, not just on the surfaces that are convenient to finish.

The brass carries a deeper, more seasoned gold tone than a fresh-polished surface — warm and amber-tinged, already beginning the progression toward the richer patina that unlacquered brass develops with water contact and daily use. The rectangular basin is spacious and practical, the rim ledge moderate and clean, the sharp corners precise. The drain sits off-center toward the front of the basin, keeping the main working area of the floor uninterrupted. Everything about this sink is resolved — not because it was designed to impress, but because it was made without shortcuts.

• Installation Type: Undermount
• Material: Solid Unlacquered Brass
• Finish: Unlacquered Living Finish — develops natural patina over time
• Basin: Single Rectangular Basin — Fully Hammered Interior & Exterior Walls
• Drain Opening: Standard 3-1/2" off-center drain
• Drain: Brass drain body included
• Mounting Hardware: Included
• Customization: Yes — custom sizes available